JMC iHSS60-36-30-21-38 Closed Loop Steppermotor with integrated driver 3 Nm

JMC Closed Loop Steppermotor with integrated driver 3 Nm 

IHSS60-36-30-21-38 Nema 24

Max. Torque: 3Nm
Shaft length: 21 mm
Schaft diameter: 8mm
Centric diamer: 38 mm
Total length: ca. 117mm
Flange size: NEMA24/ 60x60mm
Hole distance: 47,14 mm

Eigenschaften:

• Cost-effective closed loop stepper motor solution
• High position accuracy through position feedback
• No step losses
• Smooth and even engine running at low speeds
• Compact size
• Input signal: pulse / direction (PUL/DIR)
• Variable power control technology, thus high efficiency
• Parameters can be transferred to the PC via RS232.
• Settings via DIP switches or software.
• Over current protection, over voltage protection, step loss detection
• 2 Signal LED green and red indicate status
   

The iHSS57-XX stepper motors are a unit consisting of stepper motor, encoder and output stage, making the system very compact and space-saving. The position evaluation is done by an optical encoder with high speed scanning of 50 μs. As soon as a position deviation appears, it is compensated immediately. This product, combines the advantages of stepper motor drive and servo drive, such as less heat generation, less vibration, lower power consumption and high dynamics.

In most cases, these drives are ready for immediate use and do not require complex tuning like servo motors to run stable.

Technical data:

• Avoid dust, oil mist and corrosive gases
• Working temperature (motor housing) 110° max, 70° recommended
• Storage temperature -20° ... +65°
• Air humidity 40 ... 90% rel. humidity