Firmware ELS 4 Pro Version 12

Download: ELS4 Pro -V12 Please note: The settings remain intact when updating the Software! Changes in this Version: Error at very low travel speeds below 50mm/min on the Z-axis eliminated. Error in the activation of the limit inputs eliminated Instructions: Download and open the ZIP-archive. Save the included file(s) to a micro SD card. Switch…

Details

Firmware ELS 4 Basic Version 11

Download: ELS4 Basic-V11 Please note: The settings remain intact when updating the Software! Changes in this Version: The activation of the limitswitch inputs was exchanged. Fixed a bug in the settings menu in English language Pause key now stops in all cycles when one cycle is complete. This can be used, for example, to remove…

Details

Firmware ELS 4 Pro Version 11

Download: ELS4 Pro -V11 Please note: The settings remain intact when updating the Software! Changes in this Version: Fixed a bug in the settings menu in English language Pause key now stops in all cycles when one cycle is complete. This can be used, for example, to remove chips from the path. Once a cut…

Details

Firmware ELS 4 Pro Version 10

Download: ELS4 Pro -V10 Please note: The settings remain intact when updating the Software! Changes in this Version: When activating the X limit switch, the enable signal for the X axis was not deactivated. External and internal turning is now only carried out at the last infeed on full length. In the passes before that,…

Details

Firmware ELS 4 Basic Version 10

Download: ELS4 Basic-V10 Please note: The settings remain intact when updating the Software! Changes in this Version: When activating the X limit switch, the enable signal for the X axis was not deactivated. External and internal turning is now only carried out at the last infeed on full length. In the passes before that, cutting…

Details

Firmware ELS 4 Basic Version 9

Download: ELS4 Basic-V9 Please note: The settings remain intact when updating the Software! Changes in this Version: General code optimizations. Error in parameter menu for tapers and radii, there the finishing feed rate could not be set lower than 100%. Smallest steps of only one motor step with XSTEP or ZSTEP are now possible System…

Details

Firmware ELS 4 Pro Version 9

Download: ELS4 Pro -V9 Please note: The settings remain intact when updating the Software! Changes in this Version: General code optimizations. Error in parameter menu for tapers and radii, there the finishing feed rate could not be set lower than 100%. Smallest steps of only one motor step with XSTEP or ZSTEP are now possible…

Details

Firmware ELS 4 Basic Version 8

Download: ELS4 Basic-V8 Changes in this Version: A change in GEARBOX mode allows the start of the cycle when the spindle is still off A parametermenu für GEARBOX mode allows a setting of a new parameter “direct drive” which allows a direct coupling of the Z-Axis with the spindle movement. Handy for spring manufacturing for…

Details

Firmware ELS 4 Pro Version 8

Download: ELS4 Pro -V8 Changes in this Version: A change in GEARBOX mode allows the start of the cycle when the spindle is still off A parametermenu für GEARBOX mode allows a setting of a new parameter “direct drive” which allows a direct coupling of the Z-Axis with the spindle movement. Handy for spring manufacturing…

Details

Firmware ELS 4 Basic Version 7

Download: ELS4 Basic-V7   Changes in this Version: An error in activating the output SPINDLE-STOP was fixed An error in delaying the ESTOP-FOLLOW output was fixed XLIMIT and ZLIMIT inputs were reversed, fixed now. Instructions: Save the included files to a micro SD card. Switch off the control unit. Insert the memory card into the…

Details