Firmware ELS 4 Basic Version 13

Download: ELS4 Basic-V13b This is a BETA version that may still contain bugs. It has been extensively and thoroughly tested, but contains many changes, so there may still be bugs. Please note: The settings remain intact when updating the Software! Changes in this Version: The displayed positions now have 3 decimal places if the value…

Firmware ELS 4 Basic Version 11

Download: ELS4 Basic-V11 Please note: The settings remain intact when updating the Software! Changes in this Version: The activation of the limitswitch inputs was exchanged. Fixed a bug in the settings menu in English language Pause key now stops in all cycles when one cycle is complete. This can be used, for example, to remove…

Firmware ELS 4 Basic Version 10

Download: ELS4 Basic-V10 Please note: The settings remain intact when updating the Software! Changes in this Version: When activating the X limit switch, the enable signal for the X axis was not deactivated. External and internal turning is now only carried out at the last infeed on full length. In the passes before that, cutting…

Firmware ELS 4 Basic Version 9

Download: ELS4 Basic-V9 Please note: The settings remain intact when updating the Software! Changes in this Version: General code optimizations. Error in parameter menu for tapers and radii, there the finishing feed rate could not be set lower than 100%. Smallest steps of only one motor step with XSTEP or ZSTEP are now possible System…

Firmware ELS 4 Basic Version 8

Download: ELS4 Basic-V8 Changes in this Version: A change in GEARBOX mode allows the start of the cycle when the spindle is still off A parametermenu für GEARBOX mode allows a setting of a new parameter “direct drive” which allows a direct coupling of the Z-Axis with the spindle movement. Handy for spring manufacturing for…

Firmware ELS 4 Basic Version 7

Download: ELS4 Basic-V7   Changes in this Version: An error in activating the output SPINDLE-STOP was fixed An error in delaying the ESTOP-FOLLOW output was fixed XLIMIT and ZLIMIT inputs were reversed, fixed now. Instructions: Save the included files to a micro SD card. Switch off the control unit. Insert the memory card into the…

Firmware ELS 4 Basic Version 6

Download: ELS4 Basic-V6   Changes in this Version: Support for external handwheel with rotary encoder: A handwheel can now be connected to the SUBD connector on the rear panel. A suitable additional board “handwheel extension” is available in the shop and allows the use of all push buttons in an external control unit. The ELS4…