Firmware ELS 4 Pro Version 12

Download: ELS4 Pro -V12 Please note: The settings remain intact when updating the Software! Changes in this Version: Error at very low travel speeds below 50mm/min on the Z-axis eliminated. Error in the activation of the limit inputs eliminated Instructions: Download and open the ZIP-archive. Save the included file(s) to a micro SD card. Switch…

Firmware ELS 4 Pro Version 11

Download: ELS4 Pro -V11 Please note: The settings remain intact when updating the Software! Changes in this Version: Fixed a bug in the settings menu in English language Pause key now stops in all cycles when one cycle is complete. This can be used, for example, to remove chips from the path. Once a cut…

Firmware ELS 4 Pro Version 10

Download: ELS4 Pro -V10 Please note: The settings remain intact when updating the Software! Changes in this Version: When activating the X limit switch, the enable signal for the X axis was not deactivated. External and internal turning is now only carried out at the last infeed on full length. In the passes before that,…

Firmware ELS 4 Pro Version 9

Download: ELS4 Pro -V9 Please note: The settings remain intact when updating the Software! Changes in this Version: General code optimizations. Error in parameter menu for tapers and radii, there the finishing feed rate could not be set lower than 100%. Smallest steps of only one motor step with XSTEP or ZSTEP are now possible…

Firmware ELS 4 Pro Version 8

Download: ELS4 Pro -V8 Changes in this Version: A change in GEARBOX mode allows the start of the cycle when the spindle is still off A parametermenu für GEARBOX mode allows a setting of a new parameter “direct drive” which allows a direct coupling of the Z-Axis with the spindle movement. Handy for spring manufacturing…

Firmware ELS 4 Pro Version 6

Download: ELS4 Pro -V6 Changes in this Version: Support for external handwheel with rotary encoder: A handwheel can now be connected to the SUBD connector on the rear panel. A suitable additional board “handwheel extension” is available in the shop and allows the use of all push buttons in an external control unit. The ELS4…

Firmware ELS 4 Pro Version 4

Download: ELS4 Pro -V4 Changes Version 4: In some situations the controller could be locked in an infinite loop when receiving a Estop or Limitswitch-event. Instructions: Download and open the ZIP-archive. Save the included file(s) to a micro SD card. Switch off the control unit. Insert the memory card into the card slot on the…

Firmware ELS 4 Pro Version 3

Download: ELS4 Pro -V3 Changes Version 3: When using XSTEP there was one additional step done in some cases. The smallest allowed step size was reduced to 0.005mm to allow a smallest diameter change of 0.01mm when using XSTEP to move the X-Axis stepwise A CONE-RATIO set in the cone mode is now resettet when…

Firmware ELS 4 Pro Version 2

Download: ELS4 Pro -V2 Changes Version 2: The inputs for XLIMIT and ZLIMIT were interchanged in the software. Anleitung: Save the included files to a micro SD card. Switch off the control unit. Insert the memory card into the card slot on the top side of the housing. Press the small programming button on the…