Software updates for thge ELS 4 Electronic Leadscrew Controller

Firmware ELS 4 Basic Version 4

Download: ELS4 Basic-V4 Changes Version 4: In some situations the controller could be locked in an infinite loop when receiving a Estop or Limitswitch-event. Anleitung: Save the included files to a micro SD card. Switch off the control unit. Insert the memory card into the card slot on the right side of the housing. Press…

Firmware ELS 4 Pro Version 4

Download: ELS4 Pro -V4 Changes Version 4: In some situations the controller could be locked in an infinite loop when receiving a Estop or Limitswitch-event. Instructions: Download and open the ZIP-archive. Save the included file(s) to a micro SD card. Switch off the control unit. Insert the memory card into the card slot on the…

Firmware ELS 4 Pro Version 3

Download: ELS4 Pro -V3 Changes Version 3: When using XSTEP there was one additional step done in some cases. The smallest allowed step size was reduced to 0.005mm to allow a smallest diameter change of 0.01mm when using XSTEP to move the X-Axis stepwise A CONE-RATIO set in the cone mode is now resettet when…

Firmware ELS 4 Pro Version 2

Download: ELS4 Pro -V2 Changes Version 2: The inputs for XLIMIT and ZLIMIT were interchanged in the software. Anleitung: Save the included files to a micro SD card. Switch off the control unit. Insert the memory card into the card slot on the top side of the housing. Press the small programming button on the…

Firmware ELS 4 Basic Version 2

Download: ELS4 Basic-V2 Changes Version 2: – Three values in the settings, Resting position, AP Finish and AP Rough could not be changed – Turning a tapered thread with radial infeed did not work correctly Anleitung: Save the included files to a micro SD card. Switch off the control unit. Insert the memory card into…